24-Port 10/100Mbps + 2- Gigabit TP/SFP Managed PoE Switch Overview: Cost effective 24 Ports Power over Ethernet with Enhanced Features for SMB PoE Networking The PLANET FGSW-2620PVM PoE Switch features 802.3af Power over Ethernet (PoE) function, which optimizes the installation and safe power management of network devices such as wireless access points (AP) , Voice over IP (VoIP) phones and IP Surveillance cameras . 802.3af PoE capabilities reduce installation costs of add-in network productivity devices. It frees the wireless AP deployment from restrictions of power outlet locations. With PoE features, power and data switching are integrated into one unit and delivered over a single
cable, eliminating costs for additional AC wiring and reducing installation time. It provides a compact, affordable, safe and reliable power solution for small
to medium enterprises. Power over Ethernet, Easy Cabling installation The PoE in-line power following the standard IEEE 802.3af makes the FGSW-2620PVM able
to power on 24 PoE compliant devices at the distance up
to 100 meters through the 4-pair Cat 5/5e UTP wire. With data and power over Ethernet from one unit, the FGSW-2620PVM shall reduce
cables deployment and eliminates the need for dedicated electrical outlets on the wall, ceiling or any unreachable place. A wire carries both data and power lowering the installation costs, simplifying the installation effort and eliminating the need for electricians or extension cords. It is also proud of the key feature – energy saving. With more efficient switching power supply, the efficiency of the FGSW-2620PVM would be much better than four linear power adapters in a long run. Centralized Power Distribution with Remote Management The remote PoE management functions of FGSW-2620PVM make it easy
to survey and control the PoE power provision
to the devices and ensure interoperability with equipment from other vendors. Via Web interface, SNMP trap and SNMP monitoring, the manager can get the PoE devices status and alert immediately. The over-temperature detection of the PoE Switch offers a safe and stable PoE operating by limit the output power according
to detected temperature
to prevent destructive breakdown caused by un-expected overheating. High Performance Wire-Speed Switching The PLANET FGSW-2620PVM offers 24 10/100Mbps Fast Ethernet ports and 2 Gigabit TP/SFP combo ports. The two Gigabit TP/SFP combo ports can be either 1000Base-T for 10/100/1000Mbps or 1000Base-SX/LX through SFP (Small Factor Pluggable) interface. PLANET FGSW-2620PVM boasts a high performance switch architecture that is capable of providing non-blocking switch fabric and wire-speed throughput as high as 8.8Gbps. Its two built-in GbE uplink ports also offer incredible extensibility, flexibility and connectivity
to the Core switch or Servers. Key Features: Physical Port Â* 24-Port 10/100Mbps Fast Ethernet ports with PoE Injector Â* 2 10/100/1000Mbps TP and SFP shared combo interfaces Â* RS-232 male
DB9 console interface for Switch basic management and setup Â* Reset button for system management Power over Ethernet Â* Complies with IEEE 802.3af Power over Ethernet End-Span PSE Â* Up
to 24 IEEE 802.3af devices powered Â* PoE Power up
to 15.4 Watts for each PoE port Â* Auto detect powered device (PD) Â* Circuit protection prevent power interference between ports Â* Remote power feeding up
to 100m Â* PoE Management –Total PoE power budget control –Per port PoE function enable/disable –PoE Port Power feeding priority –Per PoE port power limit –PD classification detection Layer 2 Features Â* Complies with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z Gigabit Ethernet standard Â* Supports Auto-negotiation and Full-Duplex / Half-Duplex modes for all 10Base- T/100Base-TX and 1000Base-T ports Â* Auto-MDI/MDI-X detection for each RJ-45 port Â* Prevents packet loss Flow Control: –IEEE 802.3x Pause Frame flow control for Full-Duplex mode –Back-Pressure Flow Control in Half-Duplex mode Â* High performance of Store-and-Forward architecture, runt/CRC filtering eliminate erroneous packets
to optimize the network bandwidth Â* Broadcast / Multicast / Unicast storm control Â* 8K MAC address table, automatic source address learning and ageing Â* VLANs –IEEE 802.1Q Tag-based VLAN –Port-Based VLAN –Q-in-Q tunneling –Up
to 255 VLANs groups, out of 4041 VLAN IDs Â* Link Aggregation –up
to 13 trunk groups –up
to 8 ports per trunk group with 1.6Gbps bandwidth (Full Duplex Mode) –IEEE 802.3ad LACP (Link Aggregation Control Protocol) –Cisco ether-channel (Static Trunk) Â* Spanning Tree Protocol –STP, IEEE 802.1D (Classic Spanning Tree Protocol) –RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol) Â* Port Mirroring
to monitor the incoming or outgoing traffic on a particular port Quality of Service Â* 4 priority queues on all switch ports Â* Traffic classification: –IEEE 802.1p CoS –IP TOS / DSCP
to 802.1p priority mapping –Port-Based priority Â* Strict priority and Weighted Round Robin (WRR) CoS policies Â* QoS and In / Out bandwidth control on each port Multicast Â* IGMP Snooping v1 and v2 Â* IGMP Snooping v2 fast leave Â* Querier mode support Security Â* IEEE 802.1x Port-Based network access control protocol Â* RADIUS users access authentication Â* L2 / L3 / L4 Access Control List (ACL) Â* MAC Filtering and Source IP-MAC / Port-Binding Â* Port Security for Source MAC address entries filtering Management Â* Switch Management Interface –Console / Telnet Command Line Interface –Web switch management –SNMP v1, v2c switch management –SSL switch management Â* DHCP client for IP address assignment Â* Built-in Trivial File Transfer Protocol (TFTP) client Â* Firmware upgrade via TFTP or HTTP Â* Configuration upload / download via TFTP or HTTP Â* Four RMON groups 1, 2, 3,
9 (history, statistics, alarms, and events) Â* SNMP trap for interface Link Up and Link Down notification Â* Ping function Specification: Model FGSW-2620PVM Hardware Specification 10/100Mbps Copper Ports 24 10/ 100Base-TX RJ-45 Auto-MDI/MDI-X ports 1000Mbps Copper Ports 2 10/100/1000Mbps RJ-45 Auto-MDI/MDI-X ports SFP/mini-GBIC Slots 2 1000Base-SX/LX/BX, shared with Port-25~Port-26 Switch Architecture Store-and-Forward Switch Fabric 8.8Gbps / non-blocking Switch Throughput 6.547Mpps @64Bytes Address Table 8K entries Share Data Buffer 512Kbytes Maximum Frame Size
9K Bytes Flow Control Back pressure for Half-Duplex IEEE 802.3x Pause Frame for Full-Duplex LED Power, FAN Alarm Link/Activity (Green) PoE In-Use (Amber) 1000 LNK / ACT(Green) 10/100 LNK / ACT(Green) Reset Button > 5 sec: Factory Default Dimension (W x D x H) 440 x 265 x 44 mm, 1U height Weight 3.6kg Power Requirement 100~240V AC, 50-60 Hz Power Consumption / Dissipation 210 Watts maximum / 717 BTU/hr maximum Power over Ethernet PoE Standard IEEE 802.3af Power over Ethernet / PSE PoE Power Supply Type End-Span PoE Power Output Per Port 48V DC, 350mA . Max. 15.4 Watts Power
Pin Assignment 1/2(+), 3/6(-) PoE Power Budget 190 Watts Max. number of Class 2 PD 24 Max. number of Class 3 PD 12 Layer 2 Function Management Interface Console, Telnet, Web Browser, SSL, SNMPv1, v2c Port Configuration Port disable/enable Auto-negotiation 10/100/1000Mbps full and half duplex mode selection Flow Control disable / enable Port Status Display each port's speed duplex mode, link status and Flow control status. Auto negotiation status, trunk status. Bandwidth Control Ingress / Egress Rate Control Allow
to configure per 128Kbps VLAN IEEE 802.1Q Tag-based VLAN Port-based VLAN Q-in-Q tunneling Up
to 255 VLANs groups, out of 4041 VLAN IDs Link Aggregation Static Port Trunk IEEE 802.3ad LACP (Link Aggregation Control Protocol) Supports 13 groups of 8-Port trunk support Quality of Service Traffic classification based on: -Port priority -802.1p priority -DSCP/TOS field in IP Packet IGMP Snooping IGMP (v1/v2) Snooping, up
to 256 multicast Groups IGMP Querier support Port Mirror RX / TX / Both 1-
to-1 mirroring Security IEEE 802.1x Port-Based Network access control Port Security Static MAC MAC Filtering MAC / IP Binding Access Control List IP-Based Layer 3 / Layer 4 ACL Up
to 220 ACL rule entries SNMP MIBs RFC-1213 MIB-II RFC-2863 Interface MIB RFC-2665 EtherLike MIB RFC-1493 Bridge MIB RFC-2819 RMON MIB (Group 1, 2, 3,
9) RFC-2737 Entity MIB POWER-ETHERNET-MIB Standards Conformance Regulation Compliance FCC Part 15 Class A, CE Standards Compliance IEEE 802.3: 10Base-T IEEE 802.3u: 100Base-TX IEEE 802.3z: 1000Base- SX/LX IEEE 802.3ab: 1000Base-T IEEE 802.3x: Flow Control IEEE 802.3ad: Port trunk with LACP IEEE 802.1d: Spanning tree protocol IEEE 802.1w: Rapid spanning tree protocol IEEE 802.1p: Class of service IEEE 802.1Q: VLAN Tagging IEEE 802.1x: Port Authentication Network Control IEEE 802.3af: Power over Ethernet
... menos
| 
